Arduino的Blink範例 & (06204P:帶BNC探頭+電源)成品 20M採樣 掌上數字示波器 的整合影片

Arduino的Blink範例 & (06204P:帶BNC探頭+電源)成品 20M採樣 掌上數字示波器 的整合影片

Arduino的Blink範例 & (06204P:帶BNC探頭+電源)成品 20M採樣 掌上數字示波器 的整合影片

 

資料來源:Arduino範例 和 http://www.wp.jyetech.com/?page_id=132內的說明教學

 

 

 

/*
  Blink
  Turns on an LED on for one second, then off for one second, repeatedly.

  Most Arduinos have an on-board LED you can control. On the Uno and
  Leonardo, it is attached to digital pin 13. If you’re unsure what
  pin the on-board LED is connected to on your Arduino model, check
  the documentation at http://arduino.cc

  This example code is in the public domain.

  modified 8 May 2014
  by Scott Fitzgerald
 */

// the setup function runs once when you press reset or power the board
void setup() {
  // initialize digital pin 13 as an output.
  pinMode(13, OUTPUT);
  pinMode(8, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
  digitalWrite(13, HIGH);   // turn the LED on (HIGH is the voltage level)
  digitalWrite(8, HIGH);
  delay(1000);              // wait for a second
  digitalWrite(13, LOW);    // turn the LED off by making the voltage LOW
  digitalWrite(8, LOW);
  delay(1000);              // wait for a second
}

 

發表迴響

你的電子郵件位址並不會被公開。 必要欄位標記為 *